Archive for the ‘ Hot tub maintenance ’ Category

Tools You Will Need In Cleaning Your Hot Tub

With a hot tub comes responsibility. It’s not just about fun, you have to clean your hot tub as often as possible for hygienic purposes.

Here are some of the commonly used hot tub cleaning tools:

  1. Telepoles
    This is the main cleaning instrument you need. They are made of fiberglass of aluminum. They come in various sizes. The end has a rounded tip or a handgrip in order for your hand to not slip when you’re cleaning your pool or your hot tub. It also comes with magnets so that it can pick up metallic items such as nails or hairpins.
  2. Wall and Floor Brush
    These are used in order to remove the stains, dirt and materials that stick on the surface. The wall is there to brush off the spa and tub interior surfaces. These are often made from an aluminum frame and come with a shank that perfectly fits your grip. They have nylon bristles that can easily brush across every end.
    The curved kinds are used in order to get to those corners that are very tight. These wall and floor brushes also come in different sizes. Don’t use wire brushes that aren’t made of stainless steel because the bristles snap while you are brushing. It will also leave stains when they rust on the plaster. You also have to check whether they are rusty because these might cause further staining.
  3. Vacuum Head and Hose
    Vacuums are specially made to suck in the dirt in the spa or hot tub. There are two procedures to vacuum these equipments. The first one is to suck the dirt and sent it into the filter. The second one is to use water pressure from the hose and force the debris in the bag then removing and cleaning it with the vacuum. Vacuum heads are usually made of plastic that keeps the head above the surface as it does the cleaning. A flexible head lets the contour go in accordance with the curves of the hot tub and the spa.
  4. Tile Brush and Tile Soap
    These are used to clean the tiles. Tile brushes don’t bend too much in order to allow more cleaning. Tile soaps are often mixed of muriatic acids. These cut the stubborn oils and stains. It also eats through the plastic of the brush pads so make sure that you continue rinsing the hot tub after you apply and scrub. Don’t use other kinds of soap aside from one that is made specifically for cleaning the hot tub or spa. If you do, it might only sud and foam.
  5. Pumice Stones
    These are used in order to remove the scales from the hot tub tiles. It also removes the stains or other deposits from the surfaces. By using these, the surface isn’t excessively scratched.
    These stones are made from volcanic ash and are specifically made for abrasive actions. They are often sold in blocks and are attached to the telepoles or brushes in order to reach the surface easier. Pumice stones disintegrate so we suggest that you do the scrubbing before you do the vacuuming. Another alternative for pumice stones are plastic foams or Styrofoam because these do not scratch the fiberglass. Read more

Hot Tub Installation Planning Guide

Now that you have made the decision to purchase a hot tub, you need to think long and hard about where you will place your new hot tub. Basically, you have three choices for a location; indoors, outdoors or inside a screened in porch. The choice is completely up to you as to where you put it, but there are many considerations that you should take into account before you make your decision.

Plan Ahead For Strength And Safety

No matter where you decide to place your hot tub you need to make sure that the location has a solid foundation. What this means to you is that the foundation must be a uniformly firm, continuous, and it must provide a level setting. The recommended foundation is a concrete pad with a minimum thickness of 4 inches with steel reinforced cross bars throughout.

When installing your spa on a wood deck or balcony, the same load requirements must be met. Total load may be as much as 90 pounds per square foot. Remember that your hot tub weights about 700 pounds on its own, then when you add water and people, it could have a total weight of up to 4,000 pounds.

Regardless of the location that you decide upon, you need to be sure that the hot tub is not within 10 feet of overhead power lines and that you leave access to the internal equipment. Read more